top of page
Writer's pictureAmelie Lawrence

A Magnificent Guide to Installing Block out Roller Blinds

Early morning sunshine can disrupt your sleep and leave you feeling exhausted for the entire day. Fortunately, with block out roller blinds, you can easily solve your morning miseries. Isn’t that just great? Installing the roller blinds will be great for blocking out light, and they are a lot easier to roll up as compared to traditional blinds.

While setting up block out roller blinds is a pretty straightforward process, there are a few important steps you need to understand for a complete, successful yet effective installation and make the whole process hassle free:

Measure the Window Space

In order to ascertain what size roller blinds you need to buy, first, measure the span of the window. Block out Roller blinds can be positioned inside the window or outside the frame as you want to. Also, measure the horizontal distance between the outer points and mark them with a pencil. If you are not able to find the ideally sized roller blinds, you can buy a bigger size and cut it down for an excellent fit. Most of the blinds are designed from cardboard or aluminum and can be easily cut using a simple hacksaw.

Find out the Proper Placement

Prior to installing the brackets, you are required to find the placement of the tension chain. This will highly depend upon the space, although many people prefer the chain to hang on the right side of the blind. If the right side does not provide adequate access, you can switch the chain to the opposite side. The chain will require enough room to be placed securely against the wall outside of the frame.

Determine Roller Direction

The blind can roll up and down in two different directions either over or under the roller. Generally, the blind is placed under the roller; however, you can make it roll over if you need to avoid objects inside the frame. This is indeed quite useful if you have decorative objects or plants that rest on the window sill and you do not want to unintentionally knock them over every time you roll up the block out roller blinds.

Install Mounting Brackets

The roller blind is held in place with two brackets. One bracket is the male and the other one is the female. The tension chain is going to be on the same side as the male bracket. Set up the brackets by measuring a quarter of an inch from the top of the frame. This will enable extra clearance for when the blind is rolled up. Once the measurements are completed, do mark the screw holes with a pencil. It is always a great idea to drill a pilot hole first and cross-check that you are not drilling into pipes or electrical wires in the wall. When everything is in place, secure the brackets with the screws.

Hang the Roller

If the block out roller blinds is the right size, you can hang it on the brackets and complete the project. You just need to ensure that you are hanging the roller blinds in the right way and that the tension chain lines up with the male bracket. Secure the chain with a screw in order to avoid any choking hazards with tiny tots. If you get to this step and determine that the roller blinds are way too long for the window then you need to cut them down to size.

Cut the Blinds

For the optimal level of light blocking, you want the blinds to cover the window fully. Get started by taking the blinds off the roll and measuring the horizontal width of the window. Use that measurement to slice the fabric and the blinds. The fabric can then be cut with scissors while the roll needs to be cut with a hacksaw. When everything is the apt size, reinstall the blinds on the roll, and attach it to the mounting brackets.

Conclusion

Hopefully, you would find this comprehensive installation process of block out roller blinds helpful to redecorating the kids’ bedroom or the grown-ups. In fact, you can even layer the block out roller blinds with curtains which would give a more luxurious feel, particularly in the master bedroom.

1 view0 comments
bottom of page